Hover to zoom

1 Of 5

Honda WB30XT3A - 290 GPM (3") Water Pump

Name: Honda WB30XT3A - 290 GPM (3") Water Pump
Brand: Honda
SKU: 6303
Price: 749.00 USD
Availability: InStock

Model:

WB30XT3A

Write A Review

$749.00

Free Shipping

In-Stock

Ships Friday, Nov 22nd

Shipping to60601

Size

Honda WB30XT3A - 290 GPM (3") Water Pump

Model: WB30XT3A

$749.00

Accessories

Features

Specifications

Reviews

Product Q&A

How-To Articles

Manuals

Expert Recommended Accessories Selected by Jim, our Expert

Required Accessories 9

These accessories are required to properly setup/install this product.

Optional Accessories 10

Features

Inlet Size

3 Inch

Style

Dewatering

GPM

290 Gallons

Engine

Honda GX

3" General Purpose Water Pump
Centrifugal, self-priming design
Commercial Grade 163cc Honda OHV GX160 4-Cycle Engine
Reliable, technologically advanced & easy to start
Provides excellent torque & fuel efficiency
Protected By Honda Oil Alert® Warning System
Alerts you or shuts engine down if oil reaches an unsafe level
Helps to prevent engine seizure due to a low oil condition
Improved 4-Vane Cast Iron Impeller & Volute
Provides enhanced durability against wear & tear
Silicone-Carbide Seals
Abrasion-resistant designed for extended wear
Isolation Mounted Engine & Pump
Rubber feet minimize vibration for quieter operation
Heavy Duty Full Frame Protection
Protects the pump and engine on all sides
EPA Approved & CARB Compliant
3-Year Residential & Commercial Warranty
3" Male NPT FINE Discharge Port

California residents see

Warning: This product can expose you to chemicals including Carbon monoxide which is known to the State of California to cause Developmental Harm, and Soots, tars, and mineral oils (untreated and mildly treated oils and used engine oils) which is known to the State of California to cause Cancer.

For more information go to: www.p65Warnings.ca.gov

Specifications

WB30XT3A

General Information

Product Category

Water Pump

Pump

Gallons Per Minute

290 Gallons

Inlet Diameter

3 Inch

Outlet Diameter

3 Inch

Self Priming

Yes

Pump Head Material

Aluminum

Pump Housing Drain

Yes

Quick Clean Out

Mechanical Seal Material

Silicon Carbide

Impeller Material

Cast Iron

Solids Handling Size

.3 inch

Suction Head

25 Feet

Maximum PSI

Total Head Lift

85 Feet

Submersible

Engine

Engine Brand

Honda GX

Starting System

Recoil Start

Engine Cycles

4-Cycle

Low Oil Shutdown

Yes

Continuous Operation

Yes

163 cc

Fuel Tank Size

0.875 Gallons

Consumer Engine Warranty

3 Years

Overview

Product Category

Water Pump

Weight

57 Pounds

Made in USA

Consumer Warranty

3 Years

Product Length

20.1 Inches

Product Width

15.2 Inches

Product Height

17.9 Inches

UPC

786102002547

Additional Model Numbers

WB30, WB30XT3A

Accessories

Tool Kit

Strainer

Yes

Float Switch

Hose Couplings

Hose

Sold Separately

Hose Bands

Lifting Hook

Wheel Kit

Reviews

(25)

Honda WB30XT3A Reviews & Ratings

Product Q&A

(5)

Product Questions Answered by Jim, the Water Pump Expert

What is the horsepower of this water pump?

TOU

from Minnesota

March 11, 2024

What does the "total head lift" refer to?

Dennis F.

from Texas

March 29, 2017

Answer

Total head lift refers to the suction lift and discharge lift totaled together. The Honda WB30 is rated for a max suction lift of 25 feet at sea level and a total head lift of 85 feet. IF you were maxing out that suction lift, that would leave you a remainder of 60 feet on the discharge side of the pump, that it would handle. That said, it's not a good idea to max that out as it does work the pump to it's maximum capability. It also severely reduces the pump's GPM output. It's always best to work your pump within the middle 2/3 of the pump curve. The pump curve below may help to explain this but if you have any other questions, please let me know.

Was this answer helpful?

Yes

How long will it run on a tank of gas?

Brent

from Alabama

November 08, 2016

Answer

That's a hard question to answer Brent and there really isn't a way to gauge it. Run times are based on how easy or how hard the engine is running. If you're pumping a short distance with minimal head lift, you may see about 2 to 3 hours of run time, but if you're pumping very long distances and requiring a lot of lift, that may dwindle to 60 - 90 minutes of run time. You might equate it to how you drive your car? If you accelerate fast and brake the same and often, your gas mileage suffers. It's the same with any gas powered piece of equipment. The harder you work it, the less run time you will realize.
If you have any other questions, please let me know.

Was this answer helpful?

Yes

Jim, Do these types of trash pumps have a throttle control on them or are they pumping wide open throttle at max gpm all the time? There are times when I may want to pump 70-100 gpm but in an emergency I may need to pump 200 gpm. Do you have a better recommendation for a trash pump having similar specs. Better quality for similar price range?? Your input is greatly appreciated! Best regards,

Gary M

from Texas

May 04, 2016

Answer

While many people may use the engine throttle to control your flow rates, this can actually damage the engine and pump. The best option would be to install a ball valve on the discharge port and use that to control you flow. As long as you are not closing that flow off more than 90%-100%, you will not harm the pump or engine. If you have any other questions, please let me know.

Was this answer helpful?

Yes

Hi Jim, I would like to use the 3" Honda WB30 pump, but want to deliver water from a river to a garden plot 1,400 ft. away. Covering that much distance with 3" hose is too expensive. Is it possible to use a reducer from the 3" pressure port coupling and reduce down to a 3/4 inch pex tubing? Would this hurt the pump? Using that smaller diameter tubing would be ideal on my wallet. Also if you reduce the pressure end, do you need the source end on the suction side to be the same 3/4 inch diameter?

James L

from Tennessee

March 31, 2014

Answer

Thank you for your interest in Water Pumps Direct. Standard dewatering pumps will effectively handle pumping distances of up to about 300 feet. Once you start exceeding that, you either need to find a more powerful pump or increase your discharge hose/piping in order to overcome the friction loss that is created inside the hose/piping. So, to answer your question, the Honda WB30 nor any other pump that we offer, would not handle your 1400 foot distance and by reducing the discharge as you mentioned, you will not only reduce any possible flow to zero, you would also add the possibility of severely damaging your pump, which would not be covered under any warranty. It is never recommended to reduce the suction and/or discharge hose/pipe from the original port size.

Was this answer helpful?

Yes